High-speed 4 Axis Servo Robot

BRTNN15WSS4PF

High-speed 4 Axis Servo Robot is a product with a simple structure, stable performance, a vertical stroke of 1500mm and a load of 15KG. The decorative shells of our products are lightweight and increase the overall beauty of curves. It has been optimized and adjusted by us as a whole, and is equipped with an alarm, which improves the overall safety performance of this device during use. High-speed 4 Axis Servo Robot is widely used in industries such as automobiles, home appliances, industrial equipment, electronics, and communications.

This product is suitable for 470T-800T horizontal injection molding machine's finished products and water outlet to take out. Especially suitable for gear, pump impeller, bearing, handle, pipe, motor shell, electronic parts, clock shell, water tank shell, refrigerator shell and other injection molded parts.

Receiving posture: BRTNN15WSS4PF machine, push forward arm and close the arm against arch side. Push the transverse part so that the distance between the origin sensor and the end face of arch incision is about 70-80cm. The limit block is locked at both ends of the arch surface to prevent the pull-out and arm sliding.

Fig. 4.1 Arm retraction posture		Fig. 4.2 Attitude of drawing machine

Fig. 5.1 Sling line simulation posture

In the process of crane, the operator should wear safety helmet, standardize the operation, and pay attention to safety. In the process of operation, the machine should be pushed away from pedestrians in time to avoid passing over the head of pedestrians.

Length of hanging rope: 5.5-6 meters is appropriate, bearing: >2 ton.

Fig. 6.1 Site crane demonstration

étiquette à chaud: high-speed 4 axis servo robot, China high-speed 4 axis servo robot suppliers, manufacturers, factory